User's Guide
Introduction
Features
Requirements
Controller
Chassis
Assembly
Testing
Troubleshooting
Programming
Contests
Extending
Appendix
Hints
Polarized
Resistors
Capacitors
Servos
Batteries
Datasheets
PDXBot
RoboMaxx
Robothon
Buy Robots!
View Cart
Shipping
Privacy
About
Contact
Printable Version 
Requirements
Please read through the documentation before beginning this project. This will give you an idea of how all the pieces go together and how to make modifications. A basic knowledge of electronics, soldering, and programming is a good idea to be successful with this project.Before you start building the Mark III, be sure you have the following:
- Soldering Iron/solder
- Wire cutters
- Needle nose pliers
- Utility knife/X-Acto
- Hair dryer (for heat shrink)
- Jeweler's screwdriver (for servo adjust and JST IDC connectors)
- Plenty of time
- Digital Multi-meter (optional)
